How to Make a Waterfall Bong

A Waterfall Bong hits better, and it's cool.

Steps

This will be your burner stove.
Remove the cap from the bottle and fill it with water to within an inch of the top, holding the carburetor closed with your finger.
Take your finger off the carburetor, as the water comes out of the hole, turn on the stove, as the water level drops, it will suck the smoke out of the stove.
Advertising

For better airtightness and overall draw, consider using a glass bowl and rubber seal for another bong.
It is best to pulverize the smoking material, as this will facilitate better airflow than solid material.
Instead of using a stove, roll a joint (or joint) and insert it into the hole made in the cap.If the joint doesn't cover the hole tightly, use your fingers to plug the rest of the hole.While you wait for the bottle to be refilled, you can smoke the joint directly.
It is possible to make a hole in the bottle using the flame of a lighter.
To draw better, insert the plastic tube of a Bic pen into the hole made on the cap, then attach a straw cut to size to the end.This will allow better percolation at the bottom, which can be further improved by capping the straw and making a dozen small holes at the end, thus allowing better diffusion of the smoke, as well as increasing its cooling.
Another way to easily make a hole without using a drill is to use a pair of scissors and, once the small hole has been made, widen it by rotating the scissors inside until the stove can fit comfortably inside.
A simple way to make a stove is to shape it with aluminum foil, then apply it directly to the mouth where the cap should be screwed.Make small holes in the aluminum foil so that the smoke can pass through them.
If the burner doesn't fit snugly against the cap, use wax or rubber to seal it.

Advertising

The smoke may bother you a little as it enters your lungs.
The water may get dirty.
It will be difficult to seal the holes perfectly.
If the water comes out too slowly from the carburetor, widen it, keeping it the right size to be able to be plugged with a finger.
Prolonged use of a lighter flame to drill the hole in the plastic may result in a hole that is too large, and/or weaken the plastic too much.

Advertising

Licensed under: CC-BY-SA