The best way to clean jewelry with baking soda

news tags about us privacy
GratisForGratis

WikiHow

https://www.wikihow.it/Pulire-i-Gioielli-con-il-Bicarbonato

Instead of buying more jewelry, use baking soda to make the ones you have shine again.Its gentle cleaning power is suitable for cleaning all types of jewellery, including gold, silver and plated jewellery.Make a paste-like mixture to rub on tarnished jewelry and a cleaning solution to soak dirty jewelry in.For nickel silver (or "silver"), silver or plated jewellery, it is better to also add salt and dish detergent if you want to achieve a deeper cleaning.In all cases, baking soda will make your jewelry look like new again.

Method 1
Method 1 of 3:

Standard Cleaning

PDF download Download PDF
  1. Step 1 Versa 250 ml di acqua calda in una zuppiera.
    Consider what jewelry you want to clean, then choose an appropriately sized container.In any case, 250 ml of hot water should be sufficient.Use hot tap water or heat it in the microwave for about 30 seconds.[1]
    • If you need to clean a large piece of jewelry, for example a necklace, use more water.
  2. Watermark wikiHow to Pulire i Gioielli con il Bicarbonato
    Pour it into hot water and then stir to help it dissolve.[2]
    • If the baking soda doesn't dissolve easily, heat the water in the microwave for about thirty seconds.
  3. Watermark wikiHow to Pulire i Gioielli con il Bicarbonato
    Dip them in the water and baking soda making sure they are completely submerged.Set the timer and let them soak for 5-10 minutes to give the baking soda time to work its magic.You can clean several jewelry at once.[3]
    • The baking soda solution will remove dirt that has accumulated on the jewelry.This method is suitable for general cleaning of all types of jewelry.
  4. Step 4 Risciacqua i gioielli con l'acqua fredda per rimuovere il bicarbonato e lo sporco residuo.
    After soaking for a few minutes, they should be clean.Take them out of the bowl, rinse them with cold water, and pour the cleaning solution down the sink drain.[4]
    • If there are any small rings or earrings, fill the bowl with cold water and soak them to rinse.This way you won't risk them accidentally slipping from your hands and ending up in the sink drain.To be safe, you can rinse all valuable jewelry this way.
  5. Watermark wikiHow to Pulire i Gioielli con il Bicarbonato
    Immediately after rinsing them, dry them with a clean rag or paper towel.This way you won't risk them getting ruined.
    • At this point you can wear the jewelery again or place it in the jewelery box.
    Advertising
Method 2
Method 2 of 3:

Remove stubborn dirt

PDF download Download PDF
  1. Watermark wikiHow to Pulire i Gioielli con il Bicarbonato
    Pour three parts baking soda into a bowl and add one part water to make a paste-like cleaning mixture.Adjust the quantities based on the number of jewels to be cleaned.[5]
    • To clean a pair of jewelry, 3 tablespoons (45 g) of baking soda and one tablespoon (15 ml) of water should be enough.
    • This method allows you to effectively clean even very dirty or oxidized jewelry.
  2. Watermark wikiHow to Pulire i Gioielli con il Bicarbonato
    Mix using the handle of a toothbrush.You need to get a consistent mixture.If the two ingredients struggle to mix, add a drop more water.[6]
    • You can also mix with a spoon.
  3. Step 3 Intingi le setole pulite dello spazzolino nella miscela detergente.
    Take a generous dose to cover the entire surface of the jewelry.Try to distribute it evenly across all the bristles.[7]
    • If necessary, add a little more cleaning paste.
    • You can use a cotton swab if you don't have a new toothbrush available.Don't use a used toothbrush because it could ruin your jewelry and spread germs.
  4. Watermark wikiHow to Pulire i Gioielli con il Bicarbonato
    You can hold them in your hand or place them on a sheet of absorbent paper.Clean one piece of jewelry at a time, repeatedly moving the toothbrush back and forth.[8]
    • It's best to use a toothbrush with soft bristles because they reach the small crevices of charms, bracelets and rings better.
  5. Step 5 Continua a strofinare per un paio di minuti.
    For a thorough cleaning it is better not to rush.The time it takes to clean the jewelry depends on the amount of oxide and dirt accumulated.Continue scrubbing until you have managed to remove even the most stubborn stains.[9]
    • From time to time, run a piece of paper towel over the jewelry to remove the baking soda and check if it is clean.
  6. Watermark wikiHow to Pulire i Gioielli con il Bicarbonato
    When you are satisfied with the result obtained, rinse the jewels under running water or soak them in a bowl.Rinse them for about thirty seconds to make sure you remove all dirt and baking soda residues.[10]
  7. Step 7 Adagia i gioielli su un panno e lasciali asciugare.
    Lay out a clean cloth next to the sink to place the jewelry on after rinsing it thoroughly.Let them dry in fresh air for at least 5-10 minutes.
    Advertising
Method 3
Method 3 of 3:

Cleaning Gold or Silver Plated Jewelry

PDF download Download PDF
  1. Step 1 Scalda 250 ml di acqua nel microonde per 1-2 minuti.
    Measure it out with a measuring cup and pour it into a microwave-safe bowl.Heat it up for a couple of minutes.[11]
  2. Step 2 Rivesti l'interno della zuppiera con la carta stagnola per tenere sotto controllo i gioielli di piccole dimensioni.
    Shape a piece of paper and line the sides and bottom of the bowl.[12]
    • Tin foil is only needed if there are rings, earrings, pendants or other small jewellery.
  3. Watermark wikiHow to Pulire i Gioielli con il Bicarbonato
    Make a cleaning solution by dissolving one tablespoon (15 g) of table salt, one tablespoon (15 g) of baking soda, and one tablespoon (15 ml) of detergent in hot water.[13]
    • This mixture is suitable for removing even the most stubborn dirt.
  4. Watermark wikiHow to Pulire i Gioielli con il Bicarbonato
    If you want to clean a lot of small jewelry at once, make sure they are all completely submerged.Place them on the foil to avoid losing them.[14]
    • Set the timer and let the jewelry soak for 5-10 minutes.
  5. Step 5 Getta la soluzione detergente e risciacqua i gioielli.
    Rinse them with clean water to remove salt, baking soda, soap and residual dirt.[15]
    • Fill the bowl with clean water and rinse the jewelry thoroughly.Make sure there is no dirt, baking soda or soap left behind.
  6. Step 6 Asciuga i gioielli puliti con un panno o la carta.
    Before wearing them or putting them back in the jewelry box, gently pat them dry with paper towels or a clean cloth until they are perfectly dry.
    Advertising

Warnings

  • Delicate gems and stones, such as pearls or opals, can be cleaned with baking soda, but should not be rubbed because they could scratch.
Advertising

Things you will need

Standard Cleaning

  • 250 ml of hot water
  • 1-2 teaspoons (5-10 g) bicarbonate of soda
  • Tureen
  • Table spoon

Remove stubborn dirt

  • 3 parts bicarbonate
  • 1 part water
  • Bowl
  • New toothbrush

Cleaning Gold or Silver Plated Jewelry

  • Microwave oven
  • Tureen
  • 250ml of water
  • 1 tablespoon (15 g) salt
  • 1 tablespoon (15 g) bicarbonate of soda
  • 1 tablespoon (15 ml) dish soap
  • Foil paper
Licensed under: CC-BY-SA

Discover the site GratisForGratis

advertising

 

^