https://www.wikihow.it/Rollare-la-Marijuana
- |
Want to roll some weed but have no idea how?Read on to learn how to make regular joints and those with tobacco leaves, but you will also find some tricks for rolling special joints.
-
1Get the right amount. You need about ½ ounce of weed if you're making a joint just for yourself.When smoking with friends you will need ⅘ of a gram.For joints with tobacco leaves you need more, usually 1-2 grams.
- In any case, you can put in more than normal, resulting in a bigger joint, but it will be more difficult to maintain some sort of clarity.
- Usually, when a lot of people smoke, they put in more marijuana.
-
Grind the product. Place the flower in a grinder, turn it back and forth until the bud is evenly ground.It's best not to leave any lumps.Be sure to remove any twigs, stems or seeds.
- It may be easier to remove twigs, stems and seeds before placing the flower in the grinder.
- Some types of grinders have a special section where the yellow-white crystals of THC, called keif or keef in English.Don't forget about them because they are as precious as gold.
- Don't worry if the grass becomes sticky, that's a good sign.
-
Mix marijuana with other elements. If you want, you can mix it with other ingredients so it burns more easily.For example, add dried cannabis leaves, a little tobacco, or other products, such as resin oil, to the ground flower.
-
Get a filter pack if you plan to use them. They are narrow, white pieces of paper (usually sold in packets that look like post-it notes).Then you will have to fold them and roll them into a tube shape.First of all, fold one end like an accordion three times, until you get a sort of M.Each fold should be the thickness of a large piece of spaghetti, about half a centimeter.Then roll the rest of the paper around the M to form a tube.
- Sometimes you will hear people call it a butt.Don't get confused:a butt is the final part of the joint, the one that remains after smoking.They are related but they are not always the same thing.
-
2Take out a map. Preferably choose papers that burn slowly and evenly, which do not give a bad taste.There are some good papers also made of organic and 0 km hemp, then there are the Smoking (if you are of the "old school").
-
3Place the filter at one end of the paper. Roll just the end of the paper around the filter (make sure the glue is facing up).Close it by licking the glue.This will create a small well for the weed to sit in while you roll the rest of the joint.
-
4Put the weed in the joint. Use as much as you want, but remember that the more you put in, the harder it will be to close the joint.Practice with small amounts at first and certainly don't try to roll an entire ounce your first time!
-
Roll the joint. Bring the two ends of the paper together (as if you were folding sheets or towels), then rub them together very carefully and delicately, pressing the herb,
- Remember:basically rolling is an art.It will take some practice to get good at it and you can experiment with different methods, but the important thing is to do it with care and love.You're doing a great thing...so treat it accordingly.
-
6Seal the joint. Lick the glue to finish closing it and then smoke!
-
Get yourself a cigar. Cut it and open it with a sharp knife or cutter.You can also open it with your fingers.Remove the tobacco.Once you've opened it, lick the ends to soften the leaf and make it easier to roll.
-
Fill the tobacco leaves with grass. Add the herb you prepared.Make sure it's even.This is an important thing.If it's not even, you'll end up with air pockets that will cause the tobacco leaf to burn poorly and unevenly.
-
3Roll up the tobacco leaves. Compact the grass carefully and close the leaves by rolling them up.Holding the edge of the leaves between your thumb and forefinger, rub them together to press the herb and reduce the joint into a tube shape.
-
Close the tobacco leaves. Once you have compacted the contents, roll the leaves closed, licking the edges to seal them.
-
Heat it up if you want. If it is too wet after licking it, you can "warm" the tobacco leaves by running the flame of the lighter along the entire length, turning the tobacco leaf joint to heat it evenly.
-
1Fold the banknote. Take a 5 euro banknote or any piece of paper of the same size.Fold it in half, like a book, don't do it lengthwise.
-
2Place the marijuana on the bill. Place the chopped flower at the crease.
-
Compact marijuana. Press both sides of the bill and move your fingers down towards the marijuana, compacting it until it feels tight.It's like letting toothpaste out of the tube.Once you have compacted it well, roll the two sides of the bill back and forth so that the marijuana takes the shape of the cigarette.
-
Add the map. Insert a map (which you can buy in any tobacconist and in many other shops).Open the bill just enough to slip the paper under the marijuana.Make sure the glue on the paper is facing up.
- You can also add a filter if you want, as described below.
-
Roll the joint. Roll the joint closed and lick the sticky stripe to seal.
-
Twist the ends and enjoy. Twisting the ends will prevent the marijuana from leaking out.
- Rolling with a bill is usually considered a beginner's method.Try to avoid it if you can.
-
1Roll one tulip-shaped joint. Tulip joints are more common in Europe.Even though they seem complicated to roll, they are actually very simple.They can make a special gift for a joint-smoking girl you're trying to impress.[1]
- Prepare a joint about the length of a pencil.Cut a strip of glue from a piece of paper to close it.
- Glue two papers together, in the shape of a rectangle or square, to make a cone.Fold one corner of the square diagonally towards the other corner, just before the glue strip.Fold the glue strip down and close it to form a flat cone. Trim the excess if you want.
- Fill the cone.Open the cone and fill it with your favorite blend.
- Close the opening of the cone by bringing the edges together and pinching them together, as if you were wrapping a bottle.
- Place the joint in the opening and secure it to the cone with a rubber band, a strip of sticky paper, or dental floss.Smoke it!
-
2Roll one joint for a special Saturday evening. It's simple to roll, and perfect if the effect of just one joint isn't enough for you.It should be twice as long as normal, but remember that it is more delicate because of its length.Be careful.[2]
- Glue two papers together, narrow end to narrow end, so that the glue forms one long strip.
- Glue a third map in the center, covering the overlapping line.This third paper will help make the joint more robust.You can also skip this step if you really can't stand the taste of paper, but good luck trying to keep the joint whole.
- Roll the rest of the joint as you normally would, straight or into a cone.Smoke it!
-
3Roll one cone joint. If you want a joint like a cartoon one, then follow these steps.Eventually you will get a cone-shaped joint that ends with another cone filled with marijuana.The result will be impressive.[3]
- Make a cone, exactly as we explained for it tulip-shaped joint.But don't close the openings.
- Make a cone-shaped joint by rolling the paper around the filter, tightly and at an angle.Don't do it too much at an angle though.You might have to practice a little.The size of the opening at the end of the joint should be the same as the cone you made earlier.
- Glue the ends together and seal them with glue strips cut from other papers.Smoke it!
Advice
- Joints rolled into a cone burn better than straight ones but are more difficult to make.
- When filling a tulip or cone, it will be easier if you place it in a tall glass cup to fill it, rather than trying to hold it with your hands.Be careful not to break the glass!
- If you're having a hard time getting your joint filled, you can use a folded piece of paper or a playing card to get the weed in faster and more evenly.
- Don't make it too tight!It needs air to burn.
- You can use a pen to push and compact the weed after you roll a joint.This should give you a little extra room to fit any weed you may have dropped while rolling.
- Crumple the papers before taking a joint.It will make them easier to roll.
- If you want to add some keif - accumulated in your grinder or in a jar - scoop it up with the bar of a pen cap like a perfect little scoop.
- Some find that the coffee grinder works better than a regular grinder for picking up the keif.Experiment to find out what works best for you.
- If you're making a tulip or cone, you can always cut off excess paper to make the opening flat and even.
Warnings
- Follow the regulations on marijuana use in your area.Marijuana is not legal in all places, and in some places, the regulations can be quite complicated.Inform yourself well.
- Never drive after smoking.Like alcohol, marijuana can slow down your reaction time.You don't want to get blood on your hands.
Licensed under: CC-BY-SA